aquatek system
TRANSCRIPT
-
8/14/2019 Aquatek System
1/18
(Waterproofing System)
-
8/14/2019 Aquatek System
2/18
` AQUATEK system is an integrated waterproofing system based on
cementations products of the latest generation
` AQUATEK SUPER XA is a hybrid cement based slurry for thewaterproofing of concrete, which both acts as a water repellent coatingthrough the saturation of the capillary system.
` As a coating it forms a membrane, impervious to water but allowing
water vapour to pass.
` As a crystalline system it penetrates deep into the capillary network
of the concrete and reacts with the water and the free lime to block
the concrete capillary network.` Although the depth of penetration and extent of chemical reaction
depend on the type of concrete, its compaction etc,..
-
8/14/2019 Aquatek System
3/18
-
8/14/2019 Aquatek System
4/18
Water has penetratedthrough the capillary
system and seepage
and moisture can beseen on the exposed
concrete surface.
Magnified View of
Capillaries
-
8/14/2019 Aquatek System
5/18
Application ofAQUATEK SUPERXA.
The active ingredients
of theAQUATEK
SUPERXA penetrates
into the capillary
network of the
concrete
The active ingredients
react with the moisture
and free lime in the
concrete.
The product also forman insoluble forms a
coating.
-
8/14/2019 Aquatek System
6/18
WATERPROOFING
After the reaction, the chemical agents of AQUATEK SUPER XA form an insolublecompound which blocks the capillary network and thus renders the concrete impervious.The surface coating is also water repellent.
Application Chemical reaction Insoluble compound Blocks capillary
-
8/14/2019 Aquatek System
7/18
Permanent Protection
The chemical agents, which
have not reacted yet, remainactive.
Each time water penetrates
into the concrete again. thereaction restart
& hence also thewaterproofing processrestarts.
-
8/14/2019 Aquatek System
8/18
Aquatek SuperXA
Cement based slurry coating for the waterproofing of concrete. Waterproofs by acting as a waterrepellent coating and pore blocking through the saturation of the capillaries.
To support the working ofAQUATEK SuperXA, four other product complete range.They all have a specific field for which they can be used.
Ominitek RM Fiber
Rapid setting, waterproofing, polymer method, fibre reinforced, high strength repair mortar.
Aquatek Elastic 2C
Elastomeric, cement-based, crack bridging membrane for the waterproofing of concrete and masonry.
Aquatek Plug andAquatek Plug XF
Ultra-rapid setting mortar to AQUATEKPLUG active leaks.
Omnitek Paint EC
Elastomeric, crack bridging, anti-carbonation and decorative paint.
-
8/14/2019 Aquatek System
9/18
Sea water
Aquatek waterproofing protect the concrete from aggressive Environment.
Waste water
Aggressive under ground water
Some Chemical Solutions
Nevertheless, the composition of the concrete should be determined in terms of therequirement.
Aquatek waterproofing product also increases the wear resistance of the concrete
-
8/14/2019 Aquatek System
10/18
Concrete must have a clean surface.
Open capillary system to ensure chemical penetration andmaximum bonding.
There should be sufficient free lime in the concrete.
For the chemical reaction with the active agents to take place
This is however often not the case with old (red carbonated)concrete.
Surface to be waterproofed should be examined for structural defects.
Waterproofing with theAQUATEK system will not improve the surface textureof the concrete surface.
-
8/14/2019 Aquatek System
11/18
-
8/14/2019 Aquatek System
12/18
` AQUATEK SUPERXA integral waterproofing can be used indifferent situations on both old and new concrete.
` It can be applied on structures below as well as above water tables.
` It is especially for circumstances where secure and guaranteedwaterproofing is required.
` The waterproof coating will resist positive as well as negative waterpressure. Esp. when ve water pressure is of greater importance.
` According to different circumstances, the AQUATEK system
offers several specific water proofing techniques.
-
8/14/2019 Aquatek System
13/18
-
8/14/2019 Aquatek System
14/18
Curing
Precautions
during andafterapplication
Decorationand coating Condition ofservice
Click to exit
-
8/14/2019 Aquatek System
15/18
` AQUATEK waterproofing products are cement
based and will cure and harden in the same wayas normal concrete.
`
Setting and hardening will depend on thesurrounding temperature and humidity.
Click to GO BACK
-
8/14/2019 Aquatek System
16/18
Rain
Protect the treated surface for the min. period of 24 hrs
Sun and Wind
Protect the application against the evaporation and keepit moist.
Frost
Keep covered with insulating material.
Application Temperature.
Minimum : +5oC, Maximum : 50oC.
Ventilation
Air circulation should b provided for 24 hrs.
Click to GO BACK
-
8/14/2019 Aquatek System
17/18
` AQUATEK SUPERXA is not a decorative finish` When plaster or rendering finish is required on top of a AQUATEK treatment, it is
essential to apply this coat on a rough surface. Clean the hardened waterproofedsurface and apply a bonding slurry prior to the rendering.
` OMNITEK PAINT EC is an elastomeric, crack bridging, anti-carbonation, and decorative paint available in different colours and
can be applied overAQUATEK SUPER XA.
Click to GO BACK
-
8/14/2019 Aquatek System
18/18
Contact person
VIKALPTRIPATHI
+91-9724322264
Ameya group.